Load Paper and Ribbon
Directions

A. Raise the media door.

B. Rotate the printhead-open lever (1) couterclockwise to release the printhead mechanism (2)

C.a. Remove and discard any labels that are dirty or that are held by adhesives or tape

C.b. Slide out and flip down the media supply guide.

C.c. Place the roll of media on the media supply hanger. Push the roll back as far as it will go.

C.d. Slide in the media supply guide until it touches the edge of the roll.

D. Slide the outer media guide all the way out.

E. Slide the media under the media dancer assembly and the print mechanism. Allow the end of the media to extend out of the front of the printer.
F. Make sure that the media passes through the slot in the transmissive media sensor (1) and under the inner media guide (2). The media should just touch the back of the transmissive media sensor slot.
G. Slide in the outer media guide until it just touches the edge of the media.
H. Rotate the printhead-open lever clockwise until it locks the printhead in place.
I. Close the media door.
J. Press PAUSE to exit pause mode and enable printing. The printer may perform a label calibration or feed a label, depending on your settings.